GRAVITY & FORCED CONVECTION INCUBATORS

EXTERIOR
Tough, easy to clean semi-gloss finish. Powder coated cream or to customer's requirements.

OUTER DOOR
Well supported with robust hinges to give long life and eliminate sag. The door seals with a magnetic surround and non protruding easy opening stainless finger strip.

CONTROL PANEL
Mounted above door to give eye level vision of instruments. Solid state temperature control with digital readout and touch switch temperature selection. Controller easy to remove for quick replacement if needed. A push button reset overheat thermostat is mounted on the control panel.

INSULATION
50 mm thick grade fibreglass for minimum heat loss.

INTERIOR
All stainless steel with clear floor space for special equipment.

INNER DOOR
The glass door is fitted with robust hinges. A catch ensures positive seal against rubber surround.

SHELVES
Chrome plated straight wire type shelves allow maximum circualtion.

FORCED CONVECTION
Fan motor, rubber mounted for very quiet running.

INCUBATOR DATA

Standard units 240V 50Hz AC.
Typical Temperature Fluctuation ±0.1°C at 37°C.
Typical Temperature Variation ±0.5°C at 37°C.

GRAVITY CONVECTION INCUBATORS
Spiral type elements in the heating chamber are used for even temperature distribution. Accurate control is obtained with either a snap action hydraulic thermostat solid state analog instrument or digital indicator controller. This type can be supplied with stirrer (mechanical convection).

LARGE CAPACITY INCUBATORS
Information on incubators with a greater working volume will be provided on request.

*Special types made to customer's specifications*

CLINILAB INCUBATORS

IGCL Clinilab Incubator

A specially designed portable incubator for use in clinical, public health, and small industrial labs. Also suitable for use in school and university laboratories. Double wall construction. The exterior wall is made of heavy gauge zinc coated steel finished in polyurethane enamel. The interior wall is stainless steel. Accurate temperature control is maintained by a hydraulic thermostat. Fitted with a carrying handle, rubber feet, a removable thermometer 0 to 100°C and a hinged door. Included is a combination Petri dish rack and test tube holder, 210 mm x 117 mm, with four shelves and 32 holes, each 17 mm diameter, for test tubes.

IGCLD Clinilab Incubator

Similar to Cat. No IGCL Clinilab Incubator but designed for operation from 12V D.C. or 240 V 50 Hz (Not illustrated).

REFRIGERATED INCUBATOR

STANDARD RANGE - MODIFIED DOMESTIC FRIDGE

FEATURES:

- Solid state digital temperature control and solid state relay switching.
- Fan forced convection.
- Low and high temperature safety thermostats.
- Multiple shelf positions.
- Temperature range: 4-45°C ± 0.75°C
- "Clean Back" Internal condenser system.

EXTRAS
Diurnal lighting; timer; internal perspex door, internal power outlets, cable ports, gas purge inlets, programmable controller.

*Special units made to customer specifications

FREEZER INCUBATORS

Special units made to customer requirements

FREEZER INCUBATOR: Upright

- Solid state digital temperature control and solid state relay switching.
- Fan forced convection.
- Low temperature safety thermostat.
- Temperature range:- 8°C to ambient ±0.5°C.

Options - Chest freezer units available with external control box